Offsets

Written By: Hrvoje Dean
  • Comments: 0
  • Favorites: 0

Difficulty

Moderate

Steps

4

Time Required

Suggest a time??

Sections

1

Flags

0

Introduction

Learn how to set and change offsets for measured sensors values

  1. ONLY AUTHORIZED MAINTENANCE PERSONNEL SHOULD ENTER ADVANCED MENU AND MAKE CHANGES Picture 1. Press Menu Button Picture 2. Press Advanced button to enter Advanced menu

    • ONLY AUTHORIZED MAINTENANCE PERSONNEL SHOULD ENTER ADVANCED MENU AND MAKE CHANGES

    • Picture 1. Press Menu Button

    • Picture 2. Press Advanced button to enter Advanced menu

    • Pciture 3. Enter Admin Password Menu appears

    • Use the numbers to enter 4 digit factory preset password. Number is being displayed in the blue ribbon

    • Press DEL button to delete incorrect number

    • Press OK to confirm input

  2. Picture 1. Press Offsets button to enter Offsets menu Picture 2. Shows Offsets screen

    • Picture 1. Press Offsets button to enter Offsets menu

    • Picture 2. Shows Offsets screen

    • Picture 2. Use Home button to return to Home Screen

    • Picture 2. Use Up button to return to Advanced MenuNew line.

  3. The C35-FV can be calibrated by adjusting the offset values on the device.

    • The C35-FV can be calibrated by adjusting the offset values on the device.

    • Internal Temp offset - sets offsets for Temperature sensor inside Codis device

    • Remote Temp offset - sets offsets for Remote temperature sensor mounted on RTD input of Codis device

    • Air Quality offset - sets offsets for CO2 sensor inside Codis device

    • Relative humidity offset - sets offsets for RH sensor inside Codis device

    • NOTE: Ensure all sensors have had sufficient time to power up and stabilize prior to entering offset values.

  4. Shows current value of the sensor Shows value of offset

    • Shows current value of the sensor

    • Shows value of offset

    • Press + button to increase offset value by 0.1

    • Press - button to decrease offset value by 0.1

    • Press offset value to enter offset value entry. Use the Keybord on Picture 2. to enter Offset value. OK to confirm, Up to cancel

    • Picture 2. Use +/- button to change the sign of the number.

    • Picture 2. Use , button to place a decimal point

    • Press Save to confirm changes

Finish Line

Author

Hrvoje Dean

Member since: 12/28/2016

182 Reputation

199 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 1

All Time: 8